IMT
  
   
 

Home arrow Products arrow Ball Valves arrow Fig. 594 + 050 - Ball Valve with electric Actuator
 
 
 
Ball Valve with electric Actuator
 

Single phase, reversible synchronous Actuator with Gear Drive of tempered Steel for IMT Ball Valves of the Series 594 and 543.
On demand also available for different IMT Ball Valve Series.
Electric Actuator available as Set already mounted on the Ball Valve.

Torque Rating: 15 Nm, 20 Nm und 35 Nm depending on Ball Valve type and dimension

Higher Torques available on request for Ball Valves up to 4”
Operating Speed 60 Sec. -180 Sec. depending on turning effort
Enclosure IP 42
Voltage 230 V (+/- 10%) 50 Hz
Power Consumption 3 VA – 4,5 VA (Motor) depending on Actuator Type
Continuous Operation 100%
Rotation Angle Two-Way Ball Valve 90°, Three-Way Ball Valve 180°
Ambient Temperature -10°C to +55°C (+14°C to 131°C)
Temperature of the Media -10°C to +90°C (+14°C to +194°C) Water (no steam)

Manual Lever Handle or Square Handle Override depending on Actuator Type
Position Indicator
CE-Certification

Characteristics of the Ball Valves see Fig. 594 and Fig. 543

Other available Options:

In the Event of electrical Power Failure the Actuator closes automatically
Resistance (Heating Coil) to avoid Condensate
Relay for single phase Operation of electric Actuator
One or two auxiliary Switches (2 A) depending on Actuator
24V 50 Hz or 110V 50 Hz
IP 65 (waterproof)

Pneumatic Actuators on request

Available in:

  • Fig. 594 FF + Fig. 030.050 3/8“ – 3/4“ 15 Nm
  • Fig. 594 FF + Fig. 030.100 1“ – 1 1/4“ 20 Nm, 1 1/2“ – 2“ 35 Nm
  • Fig. 543 + Fig. 030.100 1/4“ – 1 1/4“ 20 Nm, 1 1/2“ – 2“ 35 Nm

Figure 594 - 050
 
 

Figure 594+030.050

Fig./Art. 594 FF + Fig./Art. 030.050

3/8“ – 3/4“ 15 Nm

 

Figure 594+030.100

Fig./Art. 594 FF + Fig./Art. 030.100

1“ – 1 1/4“ 20 Nm,
1 1/2“ – 2“ 35 Nm

  
 

Figure 543+030.100

Fig./Art. 543 + Fig./Art. 030.100

1/4“ – 1 1/4“ 20 Nm,
1 1/2“ – 2“ 35 Nm

 


 
Back